It isn’t written in stone at that point – I can always “undo” – and it may save me from having to go through and re-do basic formatting like case citations, block quotes, etc. When copying large blocks of text from WordPerfect (entire pleadings, etc.) into a blank Word document, though, I prefer to at least try to do a straight Copy | Paste to see what formatting issues arise. I make pretty liberal use of Paste | Special | Unformatted Text myself, and tend to prefer it when dropping fairly small amounts of text from another source into an existing Word document. What challenges have you encountered in converting existing documents to Word? Just be sure to eyeball your document thoroughly (in Print Preview if possible) before printing. I find that, even with fairly complex formatting, Word will render the text pretty much the way it appeared in WordPerfect.Įven if you use the copy-and-paste method, you might run across the occasional formatting issue. This is my preferred method - highlighting the text in WordPerfect, using CNTRL-C (or Edit, Copy) to copy the text, switching over to Word, then using CNTRL-V (or Edit, Paste) to paste the text into a blank document. Be sure to save the document under a different name with the. The formatting codes tend to be translated far better. Letting Word do the converting is usually a better choice, in my experience, than letting WordPerfect do it. Retrieving a WordPerfect document using Word. Most documents should be fine, but with more complex formatting, there could still be some issues. Exporting your document from within WordPerfect into what WordPerfect thinks is a “Word” format almost invariably results in formatting issues. Quite frankly, this is my least favorite choice. Here, I rate the choices from worst to best.

There are a lot of ways of doing this - some better than others. One question I get asked a lot is, “What’s the best way to convert an existing WordPerfect document into Word?”

Wordperfect office 13